high performance amplifier, 10 db gain, 5 - 200 mhz am-/amc-132 fp-8 v 4.00 features +49 dbm typical midband third order intercept +29 dbm typical midband 1 db compression 4.5 db typical midband noise figure description m/a-com?s am-132 is a coupler feedback amplifier with high intercept and compression points. the use of coupler feedback minimizes noise figure and current in a high intercept amplifier. this amplifier is packaged in a flatpack with flanges. due to the internal power dissipation the thermal rise should be minimized. the ground plane on the pc board should be configured to remove heat from under the package. am-132 is ideally suited for use where a high intercept, high reliability amplifier is required. c-25 absolute maximum ratings 1 parameter absolute maximum max. input power +15 dbm v bias +17.0 v operating temperature -55c to +85c storage temperature -65c to +125c 1. operation of this device above any one of these parameters may cause permanent damange. pin configuration pin # function pin # function 1 rf out 6 rf in 2 gnd 7 gnd 3 gnd 8 gnd 4 gnd 9 gnd 5 vbias 10 gnd
high performance amplifier, 10 db gain, 5 - 200 mhz am-/amc-132 specifications subject to change without notice. north america: tel. (800) 366-2266 asia/pacific: tel.+81-44-844-8296, fax +81-44-844-8298 europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 4.00 2 electrical specifications 2 t a = -55c to +85c case temperature parameter test conditions frequency units min. typ. max. gain 50 mhz @ +25c 50 mhz db 9.5 10.0 10.5 frequency response ? 5 - 200 mhz db ? ? 0.5 gain variation with temperature ? 5 - 200 mhz db ? ? 0.6 1 db compression output power 5 - 200 mhz dbm +25 ? ? noise figure ? 5 - 200 mhz db ? ? 6.0 reverse transmission ? 5 - 200 mhz db ? -14 -13 vswr ? 5 - 200 mhz ratio ? ? 1.5:1 output ip 2 two-tone inputs up to +10 dbm 5 - 200 mhz dbm +54 ? ? ? ? output ip 3 two-tone inputs up to +10 dbm 5 - 200 mhz 5 - 70 mhz dbm dbm +38 +45 ? ? ? ? vbias ? ? v 14.25 15 15.75 ibias vbias = +15.0 vdc ? ma ? 90 110 power dissipation @ +15v bias ? w ? 1.35 ? 2. all specifications apply when operated at +15 vdc, with 50 ohms source and load impedance. 3. heat sinking: operation at case temperature above 95c is not recommended. heat sinking adequate to dissipate 1.75w must be provided in use. typical performance curves intermodulation intercept gain vs. frequency 9.5 10.0 10.5 11.0 3 5 10 20 50 100 200 300 frequency (mhz) gain (db) +85c +25c -55c 60 62 64 66 68 3 5 10 20 50 100 200 300 frequency (mhz) intercept (dbm)ip2 44 46 48 50 52 intercept (dbm) ip3 ip2 ip3
high performance amplifier, 10 db gain, 5 - 200 mhz am-/amc-132 specifications subject to change without notice. north america: tel. (800) 366-2266 asia/pacific: tel.+81-44-844-8296, fax +81-44-844-8298 europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 4.00 typical performance curves noise figure and 1 db compression vswr vs. frequency 3 ordering information part number package am-132 pin fp-9 amc-132 sma c-25 1.00 1.25 1.50 1.75 2.00 3 5 10 20 50 100 200 300 frequency (mhz) vswr rf in rf out 4.0 4.5 5.0 5.5 3 5 10 20 50 100 200 300 frequency (mhz) noise figure (db) 28 29 30 31 output power (dbm) noise figure output power
|
